An Explosive Patient: Diffusing The Bomb
Yes, believe it or not, you have to diffuse a
freakin' bomb. First, you must unscrew all the
screws so you can remove the cover panel, but
each screw unscrews differently and if you mess up
more than 3 times, it'll blow up, so lemme just
tell you. Unscrew the bottom right screw to the
left, the bottom left screw to the right, the top
right screw to the left, and the top left screw
to the right. Once you're in, you'll see a
reactor core surrounded by flashing red and white
panels, but we'll save that for later. You'll pan
down to a little voltage meter and you have to
place the red pegs in the correct spots to get
the meter at the right level. First, take the peg
on the left side and place it in the hole all the
way one the top of the left side. Then take the
right peg and place it two holes down from the
top hole on the right side (the hole that is
right next to the red line on the meter) and the
voltage should be at the proper level. Now here
comes the fun part! You'll pan back to the
reactor core and nurse lady will tell you to zap
the white panels with your laser. It's pretty
simple, just zap all the white panels, being very
careful not to zap any red panels, because that
would blow it up. Also, make sure you don't
actually zap the red core itself, which would
also make the bomb go boom. After you've done
this the reactor core has been unveiled and all
you have to do is zap it, simple, right, WRONG.
Suddenly a million little red panels appear and
start to orbit in changing directions around the
core. If your aim is true, then you should be
able to zap it until it's gone, basically all you
have to do is find some way to shoot past the
little red panels and shoot the reactor core.
It's basically a matter of timing and aim, and if
you don't have either one of those, then you have
no hope at all!
Submitted by: imalluneedinlife
Added: 06 Jan 2007
Report this Hint as:
An Unlockable | Broken